6' tall single leaf driveway gate with hardware and sleeves. Includes 2 1/2" support posts/frame, two large ground sleeves with set screw (patent pending), two side diagonal braces and two regular ground sleeves with set screw (patent pending) for those braces.

Note on gate hardware: over the years we have upgraded the hardware and tubing used in these gates (our tubing is roughly one tubing gauge thicker than other gates of this type on the market). For example, the corners in the gate hardware are black galvanized steel (as opposed to aluminum found in most gates of this type). The hardware is also black - screws, turnbuckle assembly, cable clamps and even the support cable is black. Included in all 8ft wide gates and wider is our new ez-side brace assembly U.S. Patent No. 12,129,680. This assembly consists of a sleeve that is driven straight up and down vertically (as opposed to on an angle for diagonal braces) and hardware that connects the support post to the vertical sleeve. This is a much easier way to install side braces than driving a sleeve on an angle.

Note on gate width: the width selection is the approximate width of the gate including support posts, hardware and space. Please use this width as a guide rather than a rule. If you are working with a specific space please order the next gate width up and cut down the three vertical pieces to fit your space.

Note on fence mesh: These gates are designed to use fence mesh included with our fence kits. There is no fencing shipped with these gates. For example, there are 50+ different kinds of Critterfence fencing; these gates are universal and work with any fence mesh.

Note on no-climb hardware: This hardware is designed to work with our no-climb fence kits. You will need to use your existing fencing to attach to the no-climb gate extenders. If you choose this option, please be aware that your large gate can either:

1)

Have a permanent canopy across the

 

 

 

 

 

 

 

 

top of your large gate entrance. Depending on the height of your gate, this

means that if you wanted to drive a vehicle through the gate you would be

driving under the canopy. It's not necessarily an issue but you willl need to make

sure you have clearance. The gate can swing either way (in or out) with this

configuration.

 

2)

Have no-climb hardware that swings

 

 

 

 

 

 

 

 

with the gate. This means that when you open or close the gate, the overhead

no-climb hardware and canopy moves with the gate out of the way; overhead

clearance is completely free. The disadvantage with this setup is that the gate

can only swing in one direction, which is in towards the no-climb

hardware. For example, if you have a fence installed to keep your cats in with

the no-climb extenders pointed inwards to prevent cats from climbing out, this

driveway gate can only open inwards in this configuration.

 

Ground sleeves are included to provide a concrete free installation - for additional support, you can install the ground sleeves themselves in concrete (sleeves in concrete are stronger than the support post itself in concrete). Sleeves have a locking set screw to make these gates permanent or removable. Large ground sleeves are 30" long and require one large driving anvil (different from standard driving anvil used with smaller post sleeves that come with fence kits). One large anvil will work with a infinite number of large sleeves.

Note: large driving anvils work with both large and small sleeves (as used in side braces).